How to use
To Replace a Lost Filling: Wash hands. Rinse out the cavity with warm water. Do not dry; leave moist. Use the applicator to remove a small amount of material from the vial, form it into a ball with your fingers, and press firmly into the cavity.
Scrape the material off your finger by scraping your finger along the edge of the tooth. Do not lift your finger straight up as this might loosen the material in the cavity. Bite down several times to insure proper bite. REMOVE ANY EXCESS MATERIAL. RINSE OUT YOUR MOUTH WELL.
Allow two hours to set before eating. To Re-cement Loose Caps or Crowns: Wash hands. Prepare crown by carefully removing as much old cement as possible from inside the crown. Rinse well.
Clean and rinse the tooth area with water and leave moist. Fit the crown back on the tooth before applying new material. Make sure it fits properly. If you cannot do this, DO NOT PROCEED. See your dentist.
Use the applicator to remove a small amount of material from the vial.
Place a very small amount of material along the inside edge of the open end of the crown.
Place a crown on a wet tooth and press firmly. Bite down several times to ensure proper fit. If the bite is not completely comfortable, remove and repeat all steps until the crown feels normal. REMOVE ANY EXCESS MATERIAL. RINSE OUT MOUTH WELL WITH WATER.
Allow at least two hours to set before eating. Dentemp Loss Cap and Lost Filling Repair can be used to replace a bridge.
Should not be used on implants or posts without the dentist’s advice.
Hazards and Cautions
This product should not be used if throbbing pain or swelling in the affected area exists, consult your dentist immediately.
This product is sold as a temporary remedy.
See your dentist as soon as possible for permanent work to be performed. Failure to do so may cause infection and/or serious injury. Store at room temperature with the container closed to keep the material soft.
Ingredients
Calcium Sulfate, Barium Sulfate, Dimethoxytetraethylene Glycol, Zinc Oxide, Eugenol, Ethylmethacrylate Polymer.
There are no reviews yet.