Detail:
Caution:
This product should not be used if throbbing pain or swelling in the affected area exists. Consult your dentist immediately.
Store at room temperature with tube closed to keep material soft. Lot code on the container.
Directions:
Wash hands. Prepare crown by carefully removing as much old cement as possible from inside the crown. Rinse well.
Clean and rinse the tooth area with water and leave moist. Fit the crown back on the tooth before applying new material. Make sure it fits properly. If you cannot do this, DO NOT PROCEED. See your dentist.
Make sure the inside of the crown is dry. Open the tube by reversing the cap and punching a hole in the tip of the tube.
Apply a small amount of material onto the upper inside edge of the crown. Remoisten the tooth area, place a crown on the wet tooth and press firmly.
Bite down several times to ensure a proper fit. If the bite is not completely comfortable, remove and repeat all steps until the crown feels normal.
WAIT 5 MINUTES AND THEN GENTLY REMOVE ANY EXCESS MATERIAL. RINSE OUT MOUTH WELL WITH WATER. Allow at least 1 hour to set before eating.
Cement will be fully set in 1 to 3 hours. NOTE: When replacing a bridge, apply material sparingly to only 1 hollow tooth at each end of the bridge. Dentemp Recap-it Cap and Crown Repair should not be used on implants or posts without the dentist’s advice.
Ingredients:
Calcium Sulfate, Dimethoxytetraethylene Glycol, Zinc Oxide, Potassium Sulfate, Ethylmethacrylate Polymer, Triacetin.
There are no reviews yet.